Halton Indoors
Chilled Beams - Air Diffusers - Iris Dampers

Fire & Smoke Dampers

Halton offer a comprehensive range of E (integrity), S (smoke leakage) and I (insulation) classified, circular and rectangular fire and smoke dampers. All are fully compliant with the latest BS EN 1366-2 and BS EN 13501-3 standards.

This range of equipment has the benefit of being delivered ready to install, no additional mounting frames being necessary. Suitable for installation in concrete, masonry and lightweight walls and floors.

Options include trigger mechanisms, motors and compatible control systems.

Low Leakage Insulated Blade Volume Control Dampers

High quality, low leakage, insulated blade, flanged rectangular volume control dampers. Suitable for manual or motorised operation.

Modular Supply Air Diffusers

These diffusers have been specifically developed to reduce the amount of time needed to accommodate office churn. Face-plates, coanda plates and inlet spigots are all interchangeable in situ.

Variable & Constant Air Volume Terminal Units

Halton offer a range of single and dual duct VAV and CAV terminal units, together with an extensive range of optional accessories including controls, secondary attenuation and re-heat batteries to suit the most demanding system requirements.

Conical Iris Dampers

Available in a range of sizes suitable for standard circular ductwork systems. Supplied complete with swaged spigot connections with integral flexible air seal, to facilitate easy installation. Supplied factory calibrated with matching operating knob, measurement tubes and airflow/pressure chart.

Multi Service Chilled Beams

Active Chilled Beams

Active chilled beams incorporate high output cooling coils, and integral primary air plenum chambers with side located discharge nozzles. The nozzles discharge primary air, which in turn induces room air over the cooling coils. A wide range of discharge nozzle sizes provides a wide range of outputs to match the most demanding requirements.

Passive Chilled Beams

Passive chilled beams incorporate high output cooling coils.

All available in modular format, suitable for ceiling or exposed installation.

All independently tested to Eurovent standards.

Technical Support

Electronic modelling: Halton are able to offer CFD modelling of client’s application to assist in the design process.

Mock-up and testing: Halton are able to offer full-scale mock-up and testing in our purpose-made test cells within our Research & Development laboratories in Finland and France.

Laboratory facilities include thermodynamic and acoustic testing.


Technical information associated with:
 Halton Indoor Fire Safety Solutions Fire Damper Management Smoke Dampers

Halton Products Ltd
4 The Matchyns
London Road
Rivenhall
Witham
Essex
CM8 3HA

Email this company

Tel : 01376 507000
Fax : 01376 503060

Picture captions clockwise from top left:
ES Circular Fire Damper; EIS Circular Fire Damper; Milti-blade Damper; VAV Terminal Unit; Modular Active Chilled Beam; Conical Iris Damper; Modular Air Diffuser with Interchangable Frontplate; ES Rectangular Smoke Damper.