Request Information from Energy Saving Screed

Rendering floor screeds flowing screeds concrete floor screed

	Advertise your Company on Building Design
	Contact Energy Saving Screed
	Request Quote or Pre-Tender Information
	Request CPD Seminar
	Information on Energy Saving Screed


	Subscribe to Newsletter
	Employers - Advertise Job or Position
	Submit Candidates Curriculum Vitae
	Building Design Home
	Contact Building Design
	Terms of Use
	Links

	Information-Energy Saving Screed		Information on other Products
	Subscribe to Newsletter		Email Energy Saving Screed
	Contact Energy Saving Screed		Floor Screeds

The Energy Saving Screed Co Ltd

The Energy Saving Screed Company manufacture and supply high performance flowing screeds. They also offer completely ‘green’ solutions using the "eco-friendly" energy saving flowing screeds available today.

By specifying The Energy Saving Screed Company’s Ecoscreed products it is possible to save 5m² of landfill for each cubic metre of screed applied. BRE (The Building Research Establishment) maintains that 39% of the “eco-points” in a building originate from the floor construction and that 1 “eco-point” could be saved for every 1.38 tons of sand not quarried and for every 1.3 tons of glass not going to land-fill.

Ecoscreed Standard Unbonded Floors

An Eco-friendly flowing internal floor screed.

Based on Calcium Suphate for extra hardness this is a pre-mixed flowing floor screed, made from 100% recycled products. It may be laid thinner than conventional screed and it is possible to lay 1000m² in a day (at 50mm). It is ideal for use with underfloor heating and cavity floor systems but is not designed as a final wearing finish and should be primed before use or tiling.

Unbonded

Minimum thickness of 30mm.
Fix 10mm border edging strip to all walls.
Use lapped single sheet polythene not less than 500 guage.
Use unfolded polythene on rolls (folds act as crack inducers).
Tape all overlapped polythene edges except at border edge.

Floating

Minimum thickness of 40mm.
Polythene to be placed on top of insulation.
Insulation to be laid in accordance with the manufacturers recommendations.

Under Floor Heating System

Minimum screed thickness clearance over the top of the heating pipes to be 30mm.
Heating pipes should be fully secured to prevent lifting.
Heating pipes, as a general rule, should be pressure tested and waterfilled prior to screeding taking place.

Thin Section Coverings

If there is a requirement for direct fixing of thin section final finishes, such as vinyl, linoleum, etc. then the floor should be lightly sanded when sufficiently dry to remove any surface imperfections.

Bonded Floors

A fast drying covering for cement-based substates

This is an eco-friendly protein free floor leveller, supplied as a grey power ready for mixing with water. The mixed product sets within 1 hour at 20ºC and can recoated after 24 hours (at the same temperature). It is designed for resurfacing existing light industrial concrete floors and provides a fast-drying surface.

Request information: The Energy Saving Screed Company rendering floor screeds flowing screeds concrete floor screed

Free flowing floor screed