Daver Steels are manufacturers of high-strength structural tie rods and components which have a high specification finish for architectural use.
Daver Steels’ DST520 tie-rod system is produced in both carbon and stainless steel, both of whose characteristic yield strengths of 520 N/mm².
Their DST520 system provides a technical solution to design tie-rod requirements. Daver Steels have a broad range of experience with tie rod systems and are able to offer assistance to architects, designers and also to the end user.
For rapid installation on site, Daver Steels’ DST520 tendons are pre-assembled in their factory and set to their nominal pin-to-pin length. These tendons are then ready for immediate introduction into the structure and generally require no site assembly and saving valuable time.
As well as their standard range of fittings shown in their website, Daver Steels are also happy to manufacture to clients’ specific needs.
Please contact Daver Steels about any bespoke requirements, for example; special machined spades, forks or couplings, special pins or plate connections, fabricated brackets or welded plate spades.
Daver Steels also offer a steel fabrication service to the metals trade, stockists, engineers and contractors.
Daver Steels (Bar & Cable Systems) Ltd - 395 Petre Street, Sheffield, South Yorkshire S4 8LN