|
Wavin
Underfloor heating & floor heating systems information
Wavin Underfloor Heating takes a unique product-based approach to
underfloor heating. The products deliver substantial advantages over
alternative heat emitters, and go beyond conventional underfloor heating
techniques.
Based on manufactured polystyrene or timber panels that hold high
performance plastic pipe in pre-determined positions, the products
ensure:
-
Maximum thermal efficiency with reduced heat loss and lower fuel
costs
-
Even heat distribution with consistent, repeatable performance
-
Easy installation with no specialist knowledge or equipment
required
-
Choice of modular or continuous pipe systems
To meet all layout requirements
Several different products are available in the Osma Underfloor
Heating range. These provide proven, cost-effective solutions for every
type of floor construction, for both new build and refurbishment
projects.
Pocketed Polystyrene
For screeded floors. Pocketed polystyrene insulation 35mm or 50mm
thick with pipe channels at 200mm or 300mm centres. The screed wraps
round the pipe in the pockets and acts as an effective heat diffuser.
Enables use of thinner screeds - 22-65mm.
Foiled Polystyrene
For fully-floating timber floors. Extruded polystyrene insulation
35mm or 50mm thick, pre-channelled at 200mm or 300mm centres,
factory-fitted with soft temper aluminium foil for high performance heat
diffusion without creaks or ticking.
Modular Chipboard
Modular system for timber joists. 22mm T+G chipboard flooring panels
with integral 10mm pipe at 100mm centres. Versions available with pipe
covering full, three-quarter or half length of the panel. Enabling
simple installation of UFH in a timber floor. Panels are interconnected
using OsmaGold fittings fitted from above or beneath the floor level.
Timber Joist
Continuous pipe system for timber joists. Foiled 50mm polystyrene
insulation with pipe at 200mm centres for installation between joists at
400 or 600mm centres.
Modular Polystyrene
For joisted floors. Foiled 50mm polystyrene insulation modules with
pipe at 200mm centres for installation from below between joists at 400
or 600mm centres. Panels are simply interconnected using OsmaGold
fittings.
Custom Fit
For screeded or fully-floating timber floors. Patented CAD transfer
of heating design directly to a jigsaw of custom-made insulation panels
to meet precise building layout requirements. Can also be used to
integrate the installation of both heating pipe and plumbing pipe (and
electrical conduit as well if required). Particularly suitable for
projects involving multiple units and for large buildings with complex
room configurations.
[Also available] Pipe-on-mesh
Pipe, reinforcing mesh and insulation board: for on-site assembly
prior to screeding. Pipe centres are determined by the installer. Until
now, a conventional technique for underfloor heating installation.
Technical Services
OSMA systems are supported by a comprehensive Technical Advisory
Service covering all aspects of an underfloor heating project,
including:
For further information or to discuss a specific project, please
contact the Wavin Underfloor Heating Helpline:Tel: 01392 444122.
Request information:
Wavin drainage rainwater
Hep2O® plumbing soil waste
Technical information associated with:
Wavin Hep2O® Plumbing Systems Plastic Internal Plumbing
Systems
Technical information associated with:
Wavin Water Underfloor Heating UK |
